Product Information

• Mini Catalogue

Important Installation Note:

The Boost+ Single Sided Workstation Cable Tray & Screen Mounting Arm is designed to align precisely with the Boost+ leg frame and must be installed flush with the Boost+ legs for correct fitment and support.

If the workstationhas already beenfully installed,adding the cable tray afterward can bedifficult, asaccess to the mounting points is limited and the tray must sit exactly flush with the leg frame.

As shown below, installation requires removing specific screws from the workstation frame first to access the internal U bracket and mounting points inside the cable tray arm.The screws marked by the red arrows must be removedbefore proceeding with the screws marked by the blue arrows.

You will also need to loosen and remove the screw from the cable tray arm to access the internal bracket. The required hardware (4 pcs M8x10 screws and 6 pcs M6x10 screws) is located inside the arm.

In some cases,partial disassembly ofthe workstation may be required to correctly fit the cable tray after installation.For best results, we strongly recommend purchasing and installing the cable trayat the same time asthe workstation setup.